Compared with the traditional process (welding, viscose, riveting), the riveting machine has the advantages

1) Low energy consumption. Rivetless joints do not need to consume raw materials and auxiliary materials, the cost of consumption is only about 50% of spot welding. The cost of traditional technology is high and the consumables are many.

2) Cheap and durable, simple structure, easy to maintain. It costs about the same as traditional equipment. Traditional equipment is easy to aging and inconvenient to maintain

3) The joint is beautiful in appearance and does not need surface treatment. The welded surface is scarred and requires surface treatment (grinding, polishing, etc.). Viscose connection is the use of a high strength viscose, the workpiece corrosion is more serious...

4) High connection strength, the quality of the connection point can be detected without damage.

5) Long service life of rivetless connection mold. It was used 100,000 to 300,000 times on average.

6) The process is simple, without prior or post-processing (such as punching, surface treatment).

7) Solve the problem that the traditional process can not connect aluminum, magnesium, titanium and other metal materials.

8) The surface of the workpiece with coating or paint layer will not be damaged, and the multi-layer or laminated material can be connected. Conventional processes destroy the surface coating.

9) High efficiency, no noise, no smoke pollution, environmental protection. Welding process noise, smoke, sparks, dust emissions.

Use of riveting machine

1, do not process more than the nominal capacity of the workpiece

2. Don't work under high pressure for a long time.

3, the length of the riveting head should not exceed the specified value.

4. Stop for maintenance immediately in case of any abnormality, and direct fault elimination.

5. The guide rail of the equipment should be coated with butter once a month to make it lubricated and rust-proof.

6, the assembly and disassembly of the riveting head should be light, especially in the disassembly of the riveting head do not use brute force to pull out, should rotate the riveting head and pull out slowly downward force. If the rivet seat is pulled out of the normal position, the position of the rivet head will appear obvious deviation after the installation of the rivet head. At this time, the red safety cover should be removed and the rivet seat can be used only after it is installed in place, otherwise the machine is easily damaged.

7, the use of riveting head in the processing of some materials will appear slight bonding phenomenon, in order to ensure the quality of riveting, should be scheduled to clean the riveting head, prevent metal bonding thicker. The riveting head is fixed to the chuck of the lathe for cleaning, and then polished with sandpaper.

8. Carry out daily maintenance of equipment every two weeks.